Custom Winch Bumper Clevis Mount Sketch - 2x6 Tubing Design (Ford Bronco)

This document is a hand-drawn design sketch (isometric view) illustrating the fabrication of a custom winch mount bumper component. It shows a 'Clevis Mount', a small tab or bracket with a round hole (for a clevis/shackle pin), being fitted into a rectangular notch cut into a piece of 2x6 rectangular steel tubing. Dashed projection lines indicate the alignment and insertion path of the clevis mount into the notched tubing. The large angled plate in the middle is labeled 'Winch Center Section' and features an oblong slot (likely for fairlead/winch cable pass-through or mounting access). Dashed lines extending to the right show a matching notched tubing section on the opposite side, implying symmetrical clevis mounts on both ends of the winch bumper assembly. There are no dimensions, part numbers, torque specs, or vehicle-specific applicability information visible. A reader can learn the general construction concept: notching 2x6 rectangular tubing to recess weld-in clevis mount tabs on either side of a central winch mounting section, part of a homemade/custom bumper build documented across multiple related sketches (gussets, butt welds, expanded designs) in the same set.