1978 Ford Bronco Roll Cage Side-View Sketch - DIY Cage Design Outline

This document is a minimal, unlabeled line drawing uploaded as 'cageside.jpg' to a 1978 Ford Bronco gallery, part of an album with related files (basiccage2.jpg, cageback.jpg, cagefront.jpg). Consistent with its filename, it appears to be a side-view schematic sketch of a roll cage or roll bar design. The drawing shows a diagonal front line rising to a peak, a short flat top section, an angled downward line at the rear leading into a vertical rear leg, and a vertical support line dropping from the peak. There are no dimensions, measurements, angles, tube diameters, part numbers, or annotations of any kind, the drawing consists solely of unlabeled lines. As such, the document conveys only the general geometric shape/profile of the intended cage from the side; a reader can learn the approximate shape of the proposed roll cage side hoop or side profile, but no fabrication specifics. Any dimensional or material information would presumably be found in the companion drawings in the same album. The document itself contains no year, make, model, or applicability statements, so it cannot confirm or contradict the claimed 1978 Ford Bronco application.