Ford Bronco Transmission Crossmember Modification Diagram - Weld & Cut Steps

This document is a simple hand-drawn schematic (line drawing) illustrating a crossmember modification, likely related to transmission clearance based on the upload filename "tranny drawing.jpg". Two side-profile views are shown. The "Before Mod:" view depicts the original crossmember: a mostly flat member with a raised/offset section at one end and a mounting plate (with what appear to be bushings or spacers) on top. The "After Mod:" view shows the modified configuration: a raised box-shaped structure is added where the offset was. Two instructional callouts explain the procedure sequence: "Weld on before cutting the crossmember" points to the new box section, and "Cut here after welding is done" indicates the original lower portion of the crossmember to be removed after the new structure is welded in place. The drawing conveys that the reinforcement/raised section must be welded on first, and only afterward should the original crossmember material beneath it be cut out. No dimensions, part numbers, torque values, years, or vehicle model identification appear anywhere in the drawing. It was uploaded to a 1980 Ford Bronco gallery, but the document itself contains no vehicle-specific information.