Ford AOD 3-4 Shift Valve & Governor Limit Valve Install - Shift Kit Instructions

This is a scanned page from an automatic transmission valve body service/shift-kit instruction sheet, photographed 15 June 03. The left side shows a photo of a valve body separator plate/casting with two callouts: one indicating where the TM valve bottoms ("Best not to remove it") and one advising the use of a cotton swab stick as a wedge while changing the 3-4 valve. The right side contains illustrated steps: a plug note (Type 2 has a hole in both ends; install hollow end outboard with the O-ring in the outboard groove), step C showing the TV Limit Valve with an ORANGE spring, and step D covering installation of the new 3-4 Shift Valve and Governor Limit Valve. Step D identifies WHITE and RED springs, reuse of the TM valve, the 3-4 valve, an O-ring, and instructions for the Gov Limit Valve: install the O-ring, a 3/16 steel ball, the small ORANGE spring, then a cotter pin to hold the spring. A note states the kit does not fit 1979 to 82 models; a further section (partially cut off) begins instructions for the '83-up 3-4 shift valve and bushing, directing removal and discard of the original 3-4 valve.