Service Procedures — Ford Mustang 2005-2014

Technical Reference

Member-uploaded diagrams & documents for this generation. AI-classified; community-verified where badged.

Service Procedures

• Ford Supercharger Bolt Tightening Sequence Diagram (Fig. N0049439)
  This document is a single service-procedure illustration (figure number N0049439) depicting a supercharger assembly mounted atop an engine intake area. The diagram uses ten circled numbered callouts (1 through 10)…
• 2007 Ford Mustang Supercharger/Intake Bolt Tightening Sequence Diagram
  This document is a single technical line-art illustration, apparently one page of a multi-page Ford service procedure set. It depicts a top-down view of an engine component — based on the filename (SC5.gif) and…
• 2007 Ford Mustang Supercharger Intercooler Diagram - Callout Locations N0049440
  This document is a single exploded/callout illustration (Ford figure number N0049440) showing a rectangular finned core — consistent with an intercooler or charge air cooler — seated inside a larger housing, likely a…
• Ford Hub Service Procedure Illustration DF0558-A - Hub & Fastener Install Diagram
  This document is a single line-art service illustration (figure reference DF0558-A) from a Ford factory service procedure. The image shows a close-up exploded/installation view of what appears to be a wheel hub or…
• Ford Service Illustration F8870-A - Hub/Axle Component Callout Diagram
  This document is a single black-and-white line-art service illustration bearing the Ford figure reference code F8870-A. It shows an underbody/front-axle area component assembly—consistent with a hub, axle, or…
• Ford Hub/Wheel End Service Illustration F8857-B - Callout Diagram
  This document is a single line-art service illustration labeled F8857-B, showing a close-up view of a vehicle component area with two numbered callouts. Callout (1) points to a small fastener or fitting on the…
• Ford Front Wheel Hub & Steering Knuckle Diagram - Service Illustration GF0810-A
  This document is a single service-procedure illustration showing a front wheel hub and steering knuckle assembly, viewed from the outboard side with the brake rotor removed and wheel studs visible. Two numbered…
• Ford Headlamp Assembly Removal Diagram - Retainer Pins & Connector (GN0906-A)
  This document is a single exploded-view line illustration showing removal or installation of a headlamp assembly from the front of a vehicle. The drawing depicts the front corner of the vehicle structure (radiator…
• Ford Cable Routing & Connector Diagram GH0923-A - Service Illustration
  This document is a single black-and-white service illustration labeled with Ford figure number GH0923-A. It depicts a cable (consistent with the uploader's filename 'cable.gif') routed along the lower body/rocker area…
• Ford Blower Motor Removal Diagram - Mounting Screw Locations (A0073389)
  This document is a single service-procedure illustration (Ford figure ID A0073389) depicting a blower motor assembly as installed in the vehicle. The line drawing shows the blower motor mounted in the HVAC housing with…
• Ford Door Latch Actuator Cable Illustration GN3042-A - Service Procedure Figure
  This document is a single black-and-white line-art illustration from a Ford service procedure, showing a door latch/actuator assembly with an attached cable. A large black arrow points to the cable connection area at…
• Ford Actuator Service Illustration GN2626-A - Mounting/Connector Points Diagram
  This document is a single black-and-white line-art service illustration bearing the Ford graphics number GN2626-A. It contains no other text, legend, callout numbers, torque values, or part numbers. The drawing shows a…
• Ford Door Lock Actuator Mounting Screw Torque Diagram (10-14 Nm) - GN2627-A
  This document is a single-page service illustration showing the fastener locations and torque specification for a component mounted inside a vehicle door — based on the upload filename, a door lock/latch actuator. The…
• Ford Door Actuator & Linkage Service Illustration GN3036-A - Callout Diagram
  This document is a single black-and-white line illustration from a Ford service publication, identified by the figure reference code GN3036-A in the lower right corner. The drawing shows a portion of a vehicle door or…
• Ford Door Actuator Bolt Torque Spec Diagram - 12 Nm (9 lb-ft) Service Illustration
  This document is a single service illustration showing the inner side of a vehicle door with the door trim panel removed, exposing the internal door frame, window regulator/latch mechanism area, and hardware access…
• Ford PCV Hose Location Diagram - Rear of Engine Service Illustration (AA4459-A)
  This document is a single black-and-white line-art illustration from a Ford factory service publication, identified by the illustration reference code AA4459-A. It depicts the rear area of an engine as viewed in the…
• Ford 4.2L Rear Main Seal Removal Diagram - Tools 100-001 & 303-519
  This document is a single service-procedure illustration showing removal (or installation) of an engine crankshaft rear main oil seal. The line drawing depicts the rear face of an engine block/rear cover with the seal…
• Ford 4.2L V6 Lower Intake Manifold Installation Diagram - Sealer Points A26859-A
  This is a service illustration (figure A26859-A) showing an intake manifold installation procedure, most likely the lower intake manifold of a V6 engine. The drawing contains three views: at the top, an exploded view…
• Ford Crankshaft Position Sensor Ring Installation Diagram (A0032166)
  This document is a single line-art service illustration showing the installation or orientation of a crankshaft sensor ring (crankshaft position sensor pulse/trigger wheel) on the front of an engine's crankshaft. The…
• Ford Seat Latch Assembly Diagram - Service Illustration R12243-A
  This document is a single line-art service illustration, identified by the Ford figure number R12243-A, uploaded with the filename 'Seat latch.gif'. It depicts a latch or bracket mechanism — apparently a seat latch…
• Ford 4.2L V6 Cylinder Numbering & Spark Plug Wire Routing Diagram (A26864-A)
  This scanned service illustration shows the cylinder numbering and spark plug wire routing for a Ford V6 engine (filed as '4.2 order' by the uploader). The upper diagram depicts the coil pack/wire terminal area viewed…
• Ford 4.2L CHT Sensor Location Diagram - Service Illustration AV1682-A
  This document is a single black-and-white line-art service illustration bearing the Ford illustration reference number AV1682-A. It depicts a section of an engine with surrounding wiring harnesses and hoses, and a…
• Ford IAT Sensor Location Diagram - Intake Air Temperature Sensor & Connector
  This document is a single-page service illustration (Ford graphic reference A22827-A) showing the location of a sensor mounted in the engine air intake tube — consistent with the upload filename 'IAT.gif', it depicts…
• Ford Multifunction Switch Removal Diagram - Steering Column Connectors & Screws
  This document is a single service-procedure illustration (figure number GJ0848-A) showing the multifunction switch mounted on a vehicle steering column, as filed in a SuperMotors.net album for a 2007 Ford Mustang…
• Ford Multifunction Switch / Column Trim Panel Removal Illustration GJ0976-A
  This document is a single black-and-white service illustration (figure ID GJ0976-A) apparently taken from a Ford factory service procedure. It depicts an interior trim panel or shroud—likely part of a steering column…
• Ford Instrument Cluster / Multifunction Switch Location Diagram GJ0847-A
  This document is a single black-and-white line-art illustration, identified by the Ford artwork reference number GJ0847-A, of the type typically found in Ford workshop manual service procedures. The drawing shows a…
• Ford Multifunction Switch Lever Location Diagram - Steering Column Illustration
  This document is a single black-and-white line-art illustration from a Ford service procedure, uploaded under the filename 'multifunction2.gif'. The drawing depicts a portion of a vehicle's steering column and dash…
• Ford Service Illustration GJ0845-A - Component Location Callout Diagram
  This document is a single black-and-white service illustration (Ford figure reference GJ0845-A) showing a section of vehicle bodywork or interior panel with two numbered callouts. Callout 1 identifies a cylindrical…
• Ford Brake Booster Mounting Stud Diagram DH0526-A - Service Illustration
  This document is a single service-procedure illustration (Ford illustration ID DH0526-A) uploaded under the filename 'booster.gif'. The image shows a close-up cutaway/side view of a flanged component mounted to a panel…
• Ford RABS Sensor Location & Removal Illustration E10054-A - Service Diagram
  This document is a single black-and-white line-art service illustration, identified by the Ford illustration reference number E10054-A. It depicts a component—based on the upload filename, related to the RABS (Rear…
• Ford Shift Motor Removal Illustration C11699-A - Connector & Mounting Bolts
  This document is a black-and-white line-art service illustration, identified only by the Ford illustration reference number C11699-A. It depicts a motor assembly — per the uploader's filename, a transfer case shift…
• Ford 4x4 Shift Motor Electrical Connector Diagram - Service Illustration C11698-A
  This document is a single service-procedure illustration (Ford figure number C11698-A) showing an electrical connector and its mating component, marked with two numbered callouts (1 and 2). The drawing depicts a…
• Ford Transfer Case Shift Motor Mounting Bolts Diagram - Service Illustration
  This document is a single illustration from a Ford service procedure, identified by the figure code C11696-A. The uploader filed it as "shift motor 3" — apparently one page of a multi-page shift motor (transfer case…
• Ford 4x4 Transfer Case Shift Motor Connector Location Diagram (C11695-A)
  This document is a single black-and-white line illustration, apparently one page or figure from a Ford factory service procedure. It depicts a component mounted to a round housing (consistent with a transfer case shift…
• Ford Transfer Case Shift Motor Removal Diagram - Service Illustration C11694-A
  This document is a single service-procedure illustration (Ford figure reference C11694-A) showing a shift motor assembly, presumably an electric transfer case shift motor, as viewed installed with its wiring harness…
• Ford Driveshaft Slip Yoke & U-Joint Inspection Points Diagram - Fig A0014615
  This document is a single black-and-white line illustration from a Ford service procedure, identified only by the figure reference number A0014615. It depicts a driveshaft assembly, showing the slip yoke end, a…
• Ford Headlamp Assembly Removal & Installation Diagram - Service Illustration
  This document is a single exploded-view service illustration showing the removal or installation of a headlamp assembly. The line drawing depicts the front corner structure of the vehicle (radiator support / front…
• Ford Oil Pressure Sensor Location Diagram - Service Manual Illustration A0030415
  This document is a single service-manual illustration (Ford figure number A0030415) showing the location of the oil pressure sensor on an engine. The line-art drawing depicts a portion of the engine block, with…