Home/
Registry/
Ford/
Crown Victoria/
1998-2011/
“Margaret - The Vic - Christine”/
Photo
supermotors.net/registry/media/1058278
2004 Ford Crown Victoria Dynojet Dyno Sheet - 343 HP / 327 ft-lb Results
Reference · 1998-2011 Crown VictoriaAll 82 data & spec plates
Dynojet WINPEP performance evaluation dyno chart (LS3) plotting power and torque vs engine RPM for three run files; peak power 343.63 hp and peak torque 327.48 ft-lbs at the wheels.
Part of 1998-2011 Ford Crown Victoria Data & Spec Plates
This document is a Dynojet WINPEP 7 (Dynojet Performance Evaluation Program) chassis dynamometer results sheet showing three dyno pulls performed on 7/24/2014. The graph plots Power (hp, 0-400) and Torque (ft-lbs, 50-350) against Engine Speed (2,000-7,000 RPM), using the STD correction factor with smoothing of 5. Three runs are recorded: RunFile_002.drf (Max Power 340.97 hp, Max Torque 327.48 ft-lbs, run at 1:37:53 AM with 74.27 °F conditions), RunFile_010.drf (Max Power 340.31 hp, Max Torque 324.68 ft-lbs, run at 1:27:16 PM, 80.07 °F, 29.15 in-Hg, 23% humidity, STD 1.04), and RunFile_011.drf (Max Power 343.63 hp, Max Torque 325.91 ft-lbs, run at 1:39:24 PM, 79.87 °F, 29.17 in-Hg, 22% humidity, STD 1.04). A cursor at 5,001 RPM shows torque readings of 323.99, 323.91, and 320.90 ft-lbs and power readings of 308.40, 308.48, and 305.53 hp. The sheet does not identify the vehicle; it is filed under a 2004 Ford Crown Victoria on SuperMotors.net. Readers can learn peak power/torque figures and the consistency across the three back-to-back runs.
Is this accurate? Sign in to help verify it.
Frequently asked questions
- What was the best max power recorded on this dyno sheet?
- RunFile_011.drf recorded the highest max power at 343.63 hp, with max torque of 325.91 ft-lbs.
- What max torque values were measured across the three runs?
- Max torque was 327.48 ft-lbs (RunFile_002), 324.68 ft-lbs (RunFile_010), and 325.91 ft-lbs (RunFile_011).
- When were the dyno runs performed?
- All three runs were on 7/24/2014: RunFile_002 at 1:37:53 AM, RunFile_010 at 1:27:16 PM, and RunFile_011 at 1:39:24 PM.
- What correction factor and smoothing were used?
- The graph uses the STD correction factor (CF: STD) with a smoothing setting of 5; runs 010 and 011 show an STD factor of 1.04.
- What were the power and torque readings at about 5,000 RPM?
- At the cursor position X = 5.001 (about 5,001 RPM), torque readings were 323.99, 323.91, and 320.90 ft-lbs, and power readings were 308.40, 308.48, and 305.53 hp.
No comments yet.