2000-2006 Suburban / Yukon XL 3rd Row Bench Seat Bracket Installation Guide
Reference · 1980-1986 BroncoAll 40 service procedures
Printed bracket-system installation instructions with hardware diagram and numbered steps for a Suburban/Yukon XL 3rd-row bench seat.
Part of 1980-1986 Ford Bronco Service Procedures
This document is page one of an aftermarket installation instruction sheet for a bracket system used to mount a bench-style third-row seat in 2000-2006 Chevrolet Suburban or GMC Yukon XL vehicles. The sheet is produced by a small vendor ('Custom_Manufacturing' on eBay) with reordering contact info: phone 772-501-0128 and email [email protected]. The top of the page shows an illustration of the included hardware: roughly ten bolts with matching washers and nuts, several long bracket bars, and small square plates. The visible instructions cover the first three steps of installation: (1) pull the cargo-area carpet away from the side plastic panels and roll it forward; (2) pull up and roll forward the padding underneath in the same manner (a photo shows the exposed metal floor pan with carpet/padding rolled forward); and (3) lay out the brackets by latching them to the seat and positioning the seat in the vehicle, sliding the brackets left or right as needed to accommodate the 'hills and valleys' (contours) of the floor pan. A reader learns what hardware is supplied, how to prepare the floor, and how brackets are positioned; subsequent steps are presumably on additional pages not shown.
This document covers 2000-2006, which may differ from this 1980 Ford Bronco.
Is this accurate? Sign in to help verify it.
Frequently asked questions
- What vehicles does this 3rd row seat bracket kit fit?
- The document states it is for 2000-2006 Suburban or Yukon XL bench-style 3rd row seats.
- How do I prepare the cargo floor before installing the brackets?
- Pull up the carpet by pulling it away from the edges so it slides out from the side plastic panels, roll it forward as far as you can, then pull up the padding the same way and roll it forward as well.
- Do the brackets need to be in one exact position?
- No. The instructions say you can slide the brackets left to right a bit, and they can vary somewhat from left to right, to compensate for any hills or valleys in your floor.
- How can I reorder this bracket kit?
- Call 772-501-0128, email [email protected], or find the seller 'Custom_Manufacturing' on eBay.
- How are the brackets attached to the seat?
- You lay out the brackets by latching them to the seat, then position the seat in the vehicle.
No comments yet.