Airbag.JPG 1611 hits | 84.02 KB | Posted: 7/10/03 This is the back of a '94-96 airbag, the same for most Ford cars & trucks.
Red: shaped charge
Yell...
CowlDrain.JPG 1058 hits | 70.25 KB | Posted: 7/10/03 This is where leaves build up, on both sides of the truck. The come thru the wiper valance slots ('...
D50.JPG 1153 hits | 85.02 KB | Posted: 7/10/03 Dana 50IFS axles can be differentiated from D44IFSs by the "50" cast into the third member, and the ...
Door hinge.JPG 1687 hits | 71.28 KB | Posted: 7/10/03 This is the best way I've found to adjust or replace door hinges.
Driveshafts.JPG 599 hits | 69.62 KB | Posted: 7/10/03 Front shafts are the same for all pickups & Broncos with the same transmission length. Rear shafts ...
EEC Install.JPG 1286 hits | 93.23 KB | Posted: 7/10/03 This is how I fit the '95 EEC into an '82 Bronco body tub.
IgnitionRodTilt.JPG 1026 hits | 82.91 KB | Posted: 7/10/03 This is the ignition pushrod in '92-96 tilt columns. It's the plastic gear rack. The L section of ...
Jump Seats.JPG 774 hits | 94.07 KB | Posted: 7/10/03 These jump seats are from a '78 Datsun/Nissan King Cab pickup, and they're easy to bolt onto any flo...
Leaves.jpg 2387 hits | 74.76 KB | Posted: 7/10/03 This shows where leaves build up in '80-96 truck ductwork.
Orifice Tube.JPG 890 hits | 66.49 KB | Posted: 7/10/03 This was after my compressor crapped out. The 2 ears at the top are supposed to keep it from slidin...
PCM Inside Text.JPG 1395 hits | 78.96 KB | Posted: 7/10/03 This is what my '83 kick looks like with the '95 computer mounted.
DPFE.jpg 1327 hits | 68.17 KB | Posted: 7/10/03 DPFE with 2 rubber hoses. A sensor with only 1 hose is a PFE. Most '80-95 trucks had NEITHER.
BW-1356 Slip.JPG 546 hits | 119 KB | Posted: 7/10/03 BW-1356 for F-series with mechanical shifter
ReelLight1.JPG 996 hits | 70.04 KB | Posted: 7/10/03 This light was used on '80-96 Ford trucks and some Jeep Cherokees (with a different connector). It ...
Rod Clips.JPG 517 hits | 50.11 KB | Posted: 7/10/03 This type of rod keep is used in doors & tailgates.
Shocks.jpg 2149 hits | 67.58 KB | Posted: 7/10/03 These are the best shocks I've found for the money. ~$25/ea with a lifetime warranty. These 3 PNs ...
Shock Studs.jpg 787 hits | 29.1 KB | Posted: 9/27/04 Front front shock studs, included in the CarQuest box.
SliderLatch1.JPG 683 hits | 78.79 KB | Posted: 7/10/03 This is the latch used on '80-83 Bronco sliding side windows. If you have one to sell, contact me a...
Solenoids.jpg 3322 hits | 95.24 KB | Posted: 7/10/03 Emissions components on an early EFI.
Spring Bushing Chisels.JPG 746 hits | 74.03 KB | Posted: 7/10/03 After fighting this bushing, I figured out this method. Be careful removing the chisels - they FLY.
TempDoor.JPG 935 hits | 78.58 KB | Posted: 7/10/03 This is looking rearward over the R wheelwell with the evaporator cover removed beside the R exhaust...
Trans Manuals.jpg 1081 hits | 48.35 KB | Posted: 7/10/03 Old Manual Transmissions
Turn Cam.JPG 751 hits | 63.53 KB | Posted: 7/10/03 The bosses on the other side aren't molded right, so it doesn't return to center, and you have to be...
VSS 2.JPG 1021 hits | 90.41 KB | Posted: 7/10/03 This is the Vehicle Speed Sensor used on early (pre-'87) cruise systems. It's in the middle of the ...
Wiper Valance 2.JPG 784 hits | 116.24 KB | Posted: 7/10/03 This shows the differences in the '91 & '92 wiper valances. The '80-86 valance is just like the '87...
ValleyGunk.JPG 1631 hits | 139.16 KB | Posted: 7/14/03 The inside of a '93 5.8L with ~140,000mi. The previous owner probably used Quaker State.
PSOM961.JPG 1193 hits | 80.42 KB | Posted: 7/17/03 This is while I was running up miles on a '96 PSOM using a computer-generated tone coming thru the s...
Battery.JPG 1133 hits | 82.75 KB | Posted: 7/17/03 This is the best battery for the money. ~$80 with an 8-year warranty, the first 3 of which are free...
SteeringWheel 1.JPG 516 hits | 87.7 KB | Posted: 12/6/04 The horn pad connector is the same for all '78-91 steering wheels, regardless of shape or cruise con...
SteeringWheel 2.JPG 740 hits | 76.25 KB | Posted: 12/6/04 A cheap puller makes the job easier, but the wheel can usually be removed by hooking your knees behi...
SteeringWheel 3.JPG 515 hits | 84.87 KB | Posted: 12/6/04 The white crescent-shaped turn signal cam commonly breaks, and you can see where I've spliced this o...
Brake Rotor Wear.JPG 544 hits | 88.39 KB | Posted: 12/10/04 This is the result of the pad wearing away, then its backing plate eating off the inner surface of a...
93Tag1.JPG 381 hits | 23 KB | Posted: 1/8/05 Front axle tag on a '93 EB Bronco with 5-screw auto locks & 4WABS
93Tag2.JPG 357 hits | 30.22 KB | Posted: 1/8/05 Front axle tag on a '93 EB Bronco with 5-screw auto locks & 4WABS
96Tag1.JPG 757 hits | 43.49 KB | Posted: 1/8/05 Front axle tag on a '96 EB Bronco with 3-screw auto locks & 4WABS
TempBlendCable.JPG 973 hits | 37.47 KB | Posted: 11/19/05 Temperature blend door control cable for '92-96 Bronco & F-series
Airbag Falsing Sensor.JPG 1068 hits | 56.45 KB | Posted: 11/25/05 Bronco airbag safing sensor at base of R B-pillar.
ClockSpringExploded.jpg 890 hits | 26.35 KB | Posted: 12/2/05 Clock Spring ('94-up with driver's airbag) showing the film circuit which abrades & breaks over time...
CruiseRecall2.jpg 2428 hits | 50.64 KB | Posted: 12/7/05 List price on this is ~$11, but it will be installed at NO CHARGE (parts or labor) on vehicles cover...
SenderOilPress.jpg 2258 hits | 33.27 KB | Posted: 1/15/06 Oil Pressure Sender
This is the NAPA number for the old-style oil pressure sender that is needed to...
These slide-together relay sockets are from a cheap aftermarket alarm, but they can...
EUL-IMS.jpg 588 hits | 76.08 KB | Posted: 4/10/06 EUL/IMS module, found on the back of the instrument cluster in '87-89 V8s.
Extended Useful Life /...
94BodyLift.JPG 599 hits | 64.93 KB | Posted: 4/12/06 This truck was hit REALLY hard, but the body shouldn't have shifted THIS much.
94BodyMount.JPG 831 hits | 67.67 KB | Posted: 4/12/06 Here's why the body slid off during the impact. Not only does it have a body lift - they used grade...
BatteryClamps.JPG 326 hits | 61.88 KB | Posted: 4/15/06 500A Battery Clamps from NAPA for $6.69/pack of 2. I'll be using one pair for a cheapo winch that p...
12Radio.JPG 746 hits | 58.34 KB | Posted: 7/20/06 The replacement bulb for this style of radio can be very difficult to find, but here are 2 types tha...
VacHoses94_58L.JPG 676 hits | 39.76 KB | Posted: 8/24/06 The vacuum harness connector on the back of a '94 MAP 5.8L Bronco.
Hayneses.jpg 1585 hits | 24.52 KB | Posted: 10/28/06 Stolen from gp336 on eBay.
TVCableBushing.jpg 786 hits | 47.33 KB | Posted: 3/3/07 AODs are known to have problems with TV cable adjustment, and it's often due to the original rubber ...
HomeLinkMemo.JPG 257 hits | 50.71 KB | Posted: 3/18/07 I haven't decided what to do with this yet, but it's interesting. I wanted to put it in the '75 Bro...
WSTool_.jpg 483 hits | 34.04 KB | Posted: 5/12/07 This is a cheapo version of the tool, but it's effective.
WS_Tool1.jpg 181 hits | 44.73 KB | Posted: 5/12/07 The tool slips under the windshield trim. Slide it to hook the clips, beginning at a joint near a c...
WS_Tool4.jpg 161 hits | 65.73 KB | Posted: 5/12/07 Hold the tool at an angle so one point goes behind the clip.
WS_Tool5.jpg 163 hits | 41.95 KB | Posted: 5/12/07 Turn the tool to pry the clip slightly toward the center of the w/s, then lift the trim just enough ...
WS_Tool9.jpg 152 hits | 48.52 KB | Posted: 5/12/07 The lower trim clips are different, but they're released the same way.
WS_Tool7.jpg 343 hits | 45.25 KB | Posted: 5/12/07 The lower trim clips are different, but they're released the same way.
Used on '78~89 Broncos & has a teter-bar catch, like type 2....
InjectorBlower.JPG 227 hits | 77.42 KB | Posted: 7/23/07 Injector Blower used on '87-89 4.9L only
SwBrkts80-86.JPG 569 hits | 55.91 KB | Posted: 12/8/06 Type 1 ('80-86) Swingaway Brackets have sharply angled straight corners to match the older body. '8...
EUL-IMS.JPG 241 hits | 72.71 KB | Posted: 7/23/07 EUL / IMS Module used on '87-89 V8 only.
SwingawayType2.JPG 304 hits | 68.93 KB | Posted: 7/23/07 Type 1 ('78~86) has a 2-screw notched strike for a teter-bar catch, a J-bolt mount, an UNreinforced ...
SpoilerR.JPG 125 hits | 54.09 KB | Posted: 7/23/07 Aftermarket Rear Spoiler on an '80-91 Bronco
3BoltMirror.JPG 230 hits | 57.24 KB | Posted: 7/23/07 Rare 1980 3-bolt Hi-Low Mirror used on F250-350 only
BallPinConsole.JPG 172 hits | 71.91 KB | Posted: 7/23/07 Center Console with '78-80 ball-pin snaps instead of the more common '81-91 glove-box-style catch.
D44IFS96Tag.jpg 115 hits | 77.36 KB | Posted: 7/24/07 Front axle tag on a '96 EB Bronco with 3-screw auto locks & 4WABS
General Purpose Pics
