Exploded Parts Diagrams — Ford Bronco 1987-1991
Technical Reference
Member-uploaded diagrams & documents for this generation. AI-classified; community-verified where badged.
Exploded Parts
- Parts/routing diagram showing the PCV valve and elbow assembly, hose, and intake manifold fitting on the engine.
- Parts diagram of a typical 5.8L PCV system showing the PCV valve, hoses, clamp, elbow, and intake manifold fitting with part numbers and torque.
- Exploded parts diagram of the air intake duct and air cleaner assembly with numbered and lettered callouts and a front-of-vehicle reference.
- Exploded parts diagram of an air intake system showing the duct, air cleaner housing, and resonator with numbered and lettered component callouts.
- Exploded installation diagram of the idle air adjust spacer with gaskets, IABP solenoid, trim screws and alignment notes.
- Exploded parts diagram of the instrument panel/dashboard assembly with numbered component callouts.
- Component location view (sheet 2 of 2) for Ford 5.0L/5.8L engine identifying MAP, knock, air charge temp sensors, EGR/thermactor solenoids, fuel pump/starter relays, oil pressure sender and DRL module.
- Exploded parts diagram of a tailgate power-window assembly showing regulator, motor, run channels and seal components.
- Exploded parts diagram of the thermactor air-injection plumbing showing valves, hoses, air pump and Ford part numbers across two pages.
- Exploded parts diagram of the thermactor secondary-air plumbing showing hoses, check valves, air pump and Ford part numbers.
- Exploded and cutaway drawing of a gear-reduction starter motor showing the armature, planetary gear carrier, sun gear, brushes and overrunning drive.
- Exploded parts drawing of a fuel pressure regulator showing O-rings, mounting screws and the fuel injection supply manifold.
- Oil pressure gauge service page: cluster bulb/connector location, oil-pressure indicating schematic (switch closes 4.5-7.5 psi, 20 ohm resistor) and 4.9L 300 sender torque 8-18 ft-lb.
- MSD Ignition module (TFI-style) front and side views labeling the 6-pin connector: PIP, SPOUT/spark output, IDM, HOT/start/run, coil negative, and ignition ground.
- Ford detail illustration of transmission control selector indicator cable installation on a non-tilt automatic column: screw 383736, retainer 7E229, screw-and-washer 387991, cable routed outside T/S harness.
- Ford steering column exploded illustration: tilt and non-tilt automatic columns, shift indicator cable routing, ignition lock cylinder and intermediate shaft with torque specs (45-68 N-m steering wheel nut).
- Exploded parts breakdown of interior trim panels, vents, speaker grilles, and fasteners with Ford part numbers (P-19846).
- Exploded parts breakdown of a door assembly showing glass, regulator, vent window, weatherstripping, and handles with Ford part numbers (P-15409).
- Exploded view of front headlamp assembly mounting: headlamp assembly 13005 (RH)/13006 (LH), retainer 13C011, bulb assembly 13465, wiring 14290; nuts torqued to 6.8 Nm (5 ft-lb).
- Solenoid body diagram identifying shift solenoids, EPC solenoid, converter and coast clutch control solenoids, and TOT sensor location (D5992-1A).